Brultech Greeneye Monitor Manual de usuario descargar pdf (Pagina 20)

Temperature Menu

 Page 19

SEARCH, LIST AND SAVE ALL SENSORS

This option should only be used initially. When new sensors are added, the “Search and List All Sensors”

option in the previous section should be used for the reason described in that section.

Procedure

Make sure at least on temperature sensor is connected to the 1-Wire bus terminals.

Refer to Figure 15.

 Select the “Search, List, Save all sensor codes” (1) option and click “Go” (2)

 After a couple of seconds the ROM code for each sensor should be found and displayed as

shown in Figure 15 (3).

Notice that the found code was saved and assigned to the first channel (4).

Figure 15

Care must be taken not to use this option when more sensors are added because a newly found sensor

might be assigned to channel 1 and the current sensor displaced from channel 1 to channel2. Whether

or not this happens depends on the value of the sensor code and the algorithm used. To play it safe, the

“Search and List All Sensors” method should be used then use the manual method of entering the ROM

code and assigning it to a channel. See section “Manually Entering ROM Codes” section below.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 42 43

Sin comentarios

Brultech Greeneye Monitor Manual de usuario Pagina 20