Brultech Greeneye Monitor Manual de usuario descargar pdf (Pagina 30)

Network Menu

 Page 29

USING STATIC ADDRESS

The “Network” setup page with the “Static” option selected is shown in Figure 31Figure 32.

The “Static” (3) option is used when a specific IP address is to be assigned to the GEM. This IP address

must be on the same IP subnet as the network the GEM is connected to and must not be used by any

other device on the network. It is beyond the scope of this document to elaborate on this. Further

information can be found on the internet by searching keywords “assign static IP address local

network”.

 Local IP address

 Subnet Mask

 Local Gateway

The user must provide the following information:

 “SSID” (1) is the name of the WiFi network that the GEM will connect to

 “Password” (2) is the security password to the WiFi network you are connecting to

 “Local Port”(4) should be set to port “80”

 “IP” (5) is the local IP address of the GEM. This must be assigned by the user when “Static”

addressing is used

 “Gateway” (6) is the router’s IP address

 “Mask” is the network’s subnet mask

Figure 32

 Either the “Remote IP” (8) or the “URL” (9) value will be used for indicating the address of the

remote host. If the “Remote IP” (8) is set to “0.0.0.0”, then the “URL” (9) value will be used. An

example of a URL is “api.smartenergygroups.com”.

 “Remote Port” (10) is typically set to port “80” when sending data to a host via the internet.

Remember to click “Save” when done!

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 42 43

Sin comentarios

Brultech Greeneye Monitor Manual de usuario Pagina 30