Brultech Greeneye Monitor Manual de usuario descargar pdf (Pagina 33)

Advanced Menu

 Page 32

 “COM2 Flow” (23) enables/disables hardware flow control for the COM2 serial port. This should

be enabled only if an “XBee” module is installed.

Figure 35

 “WiFi Auto Reset Timer” (24) this function sends a timed hardware reset pulse to the

communication module connected to COM1. This includes the “WiFi Only”, “WiFi/Ethernet

Combo” and “Ethernet Only” modules. This function should only be used with the “WiFi Only”

module option under certain circumstances. The value specified is the number of seconds

between reset pulses. The purpose of this function is to be able to recover from certain

situations where loss of communication occurs. A value of “0” disables this function which is

recommended unless recommended in the “WiFi Only” setup manual.

 “WiFi No Response Counter” (25) this function sends a reset pulse to the communication

module connected to COM1. This includes the “WiFi Only”, “WiFi/Ethernet Combo” and

“Ethernet Only” modules. This function should only be used with the “WiFi Only” module option

under certain circumstances. The value specified for this function is the number times that a

packet has been sent without receiving a response from the server. After the specified number

of "no-response", a hardware pulse resets the communication module. A value of “0” disables

this function which is recommended unless recommended otherwise.

 “COM2 Auto Reset Timer” (26) this function sends a timed hardware reset pulse to the “XBee”

module. The value specified is the number of seconds between reset pulses. The purpose of this

function is to be able to recover from certain situations where loss of communication occurs. A

value of “0” disables this function which is recommended unless recommended otherwise.

 “COM2 No Response Counter” (27) this function sends a reset pulse to the “XBee module"

connected to COM2. This includes the “WiFi Only”, “WiFi/Ethernet Combo” and “Ethernet Only”

modules. The value specified for this function is the number times that a packet has been sent

without receiving a response from the server. After the specified number of no-response, a

hardware reset pulse is sent to the XBee module. A value of “0” disables this function which is

recommended unless recommended otherwise.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 42 43

Sin comentarios

Brultech Greeneye Monitor Manual de usuario Pagina 33