Brultech Greeneye Monitor Manual de usuario descargar pdf (Pagina 5)

Introduction

 Page 4

GreenEye Monitor

INTRODUCTION

OVERVIEW

The GreenEye Monitor incorporates a web interface for setting up parameters. The built-in web server

allows a browser to connect to the GEM to perform the setup process.

Early GEM models did not have this capability. GEMs with firmware versions older than “COM firmware

ver 1.70” will not support setup via web interface until the firmware is upgraded. It is recommended to

install “COM firmware ver 2.20” or higher.

FIRMWARE UPGRADE

The procedure for upgrading the firmware depends on the communication option installed in the GEM.

A dedicated manual is available for each communication option. The document code for each option is

listed below.

Communication Option

Document Name

Document Code

No communication module

GEM Setup

No Module

GEM-SET

WiFi Only

GEM Setup

WiFi Only Option

GEM-SET-W

Ethernet Only

GEM Setup

Ethernet Only Option

GEM-SET-E

WiFi / Ethernet Combination

GEM Setup

WiFi/Ethernet Combination

GEM-SET-WE

Indirect Communication via the

DashBox

GEM Setup

Via DashBox

GEM-SET-DB

Table 1

REQUIREMENT

This manual provides the procedure for setting up the GEM parameters once the hardware has been

installed. This implies that the following installation steps have been completed:

 The current transformers (CT) are installed and connected to the GEM terminals

 The potential transformer (PT) is connected

 The GEM is powered from the 5V power supply

 The GEM is connected to a network via Ethernet connection

1 2 3 4 5 6 7 8 9 10 ... 42 43

Comentarios a estos manuales

Sin comentarios

Brultech Greeneye Monitor Manual de usuario Pagina 5

Comentarios a estos manuales