Brultech Greeneye Monitor Manual de usuario descargar pdf (Pagina 29)

Network Menu

 Page 28

NETWORK MENU

Figure 30

OVERVIEW

IMPORTANT: This page will be visible only if the communication option installed in the GEM is capable

of being configured via this web interface. The Wifi/Ethernet combination module has its own dedicated

web interface for this purpose and may not be configured using this interface.

NOTE: The initial values displayed on this page are not necessarily the values set inside the WiFi module.

The displayed values reflect the last saved settings to the module. The actual values may be retrieved

from the module using the “Refresh” button. This function takes several seconds to complete.

USING DHCP

The “Network” setup page with the “DHCP” option selected is shown in Figure 31. The “DHCP” option is

commonly used when configuring the network because the following parameters are automatically

assigned by the router:

 Local IP address

 Subnet Mask

 Local Gateway

The user must provide the following information:

 “SSID” (1) is the name of the WiFi network that the GEM will connect to

 “Password” (2) is the security password to the WiFi network you are connecting to

 “Local Port”(4) should be set to port “80”

Figure 31

 Either the “Remote IP” (5) or the “URL” (6) value will be used for indicating the address of the

remote host. If the “Remote IP” (5) is set to “0.0.0.0”, then the “URL” (6) value will be used. An

example of a URL is “api.smartenergygroups.com”.

 “Remote Port” (7) is typically set to port “80” when sending data to a host via the internet.

Remember to click “Save” when done!

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 42 43

Sin comentarios

Brultech Greeneye Monitor Manual de usuario Pagina 29